Seems to be incompatible with ZNP_K1_V2.3 board

[3t4n]

I did all the firmware procedure with success, however the extruder is not being detected properly

Not sureif this is because the extruder uses a usb C instead the usual cable.

[3t4n]

[mcu THR]
serial:/dev/serial/by-id/usb-Klipper_stm32f103xe_83A73B8F0891301132363838-if00
restart_method: command

[halfmanbear]

Interesting I've not come across the ZNP_K1_V2.3 could you take a picture of the board/ the original elegoo printer.conf