MacPro 7,1 Seg fault Core dumped #14
Description
I edited the configuration and machine profiles (I added two aspi sensors TI0d, and TI1d that provided the highest temp reading) and build and installed the service, on running it I get:
sudo systemctl status macfand
● macfand.service - Mac Fan Control Daemon
Loaded: loaded (/usr/lib/systemd/system/macfand.service; enabled; preset: enabled)
Active: activating (auto-restart) (Result: core-dump) since Mon 2024-09-09 17:55:05 PDT; 960ms ago
Docs: man:macfand(1)
Process: 29327 ExecStart=/usr/local/bin/macfand -d (code=dumped, signal=SEGV)
Main PID: 29327 (code=dumped, signal=SEGV)
CPU: 2ms
There are four fans:
MacPro 7,1 conf edit:
{
sensor = "TI0d";
floor = 5;
ceiling = 120;
value = "Highest temp Reading 1";
},
{
sensor = "TI1d";
floor = 5;
ceiling = 120;
value = "Highest temp Reading 2";
},
Conf edit:
fan_ctrl = (
{
# fan 1
fan_sensors = ("TI0d", "TI1d");
floor = 45;
ceiling = 60;
min_speed = 800;
max_speed = 3600;
},
{
# fan 2
fan_sensors = ("TI0d", "TI1d");
floor = 45;
ceiling = 60;
min_speed = 800;
max_speed = 3600;
},
{
# fan 3
fan_sensors = ("TI0d", "TI1d");
floor = 45;
ceiling = 60;
min_speed = 800;
max_speed = 3600;
},
{
# fan 4
fan_sensors = ("TI0d", "TI1d");
floor = 45;
ceiling = 60;
min_speed = 800;
max_speed = 3600;
}
);
Not sure if there was anything else I needed to customize? TI0d, TI1d seem to correspond with GPU temperature on the 7,1 first GPU slot, though not sure where to find actual descriptions of these.
Ideally I would actually like to pick up the following sensors as well from, since these seem to provide higher temp readings:
enp3s0-pci-0300
#0 PHY Temperature
1 MAC Temperature
pch_lewisburg-virtual-0
0 Temp
There is also the
amdgpu-pci-0700
#0 vddgfx (this is the voltage)
1 AMDGpuT
though that value is below what the Flatpak Resources app reports for the GPU temp.