Mks Gen L v 1.0

[tunnis79]

I got a mks board but i cant get the bd sensor to work. Now i read that mks board got capacitor on the endstop so what can i use insted of the z-min can i take servo pin 5??

I got
Sda - D18 zmin
Gnd - from zmin
clk - D11 servo
5volt - 5volt servo
Gnd - Gnd servo

I got fast blinking : The sensor is connected to the 3D printer motherboard & metal detected;
and I got slow blinking : The sensor is connected to the 3D printer motherboard & no metal detected

I tried to change d18 to d5 servo but i got BD_I2C_SENSOR Init Fail return code:-2

I dont know what to do

[markniu]

For testing purposes only, you can try to use the pins in the EXP1 port.

[tunnis79]

for sda and that gnd or for both and clk

[markniu]

for both the sda and clk

[tunnis79]

i tried and i used the ground from EXP2 port its the same used pin 49 and 33

i tried the exp1 to i used the 27 and 23 and its the same cant communicate whit it

the z probe is triggered all the time but the endstop is working when i try it by hand but it does not work then i home it