nrf24l01: Properly handle timeout.

The timeout condition was not handled before.  Upon timeout, this caused
the chip to stay active until another send command changed it's state.

Sometimes when it was unable to transmit the data, it got stuck in the tx
fifo causing it to fill up over time, which set the TX_FULL flag in the
STATUS register.

Since there was no exceptions raised, the user code could not differentiate
a successful send or a timeout condition.

Signed-off-by: Marcell Pünkösd <punkosdmarcell@rocketmail.com>

Author: marcsello

micropython/drivers/radio/nrf24l01/nrf24l01.py

@@ -220,6 +220,13 @@ def send(self, buf, timeout=500):
         result = None
         while result is None and utime.ticks_diff(utime.ticks_ms(), start) < timeout:
             result = self.send_done()  # 1 == success, 2 == fail
+
+        if result is None:
+            # timed out, cancel sending and power down the module
+            self.flush_tx()
+            self.reg_write(CONFIG, self.reg_read(CONFIG) & ~PWR_UP)
+            raise OSError("timed out")
+
         if result == 2:
             raise OSError("send failed")