SBUS to PPM for Futaba Radio Help #7
Description
Dear sebseb7,
I couldn't find another way to contact you so I am contacting you like this.
I have the purchased the SBUS to PPM decoder from you and I was hoping that you can help me with the setup.
I have a Futaba T14SG transmitter and a Futaba R7008SB receiver set to "Mode B". Mode B is the mode where CH8 on the receiver becomes the S.BUS port for SBUS servos for example. However, I would like all channels to go through the S.BUS port, i.e. Channels 1 to 8 so that using a decoder, I can convert the S.BUS to a PPM-Combined for channels 1 to 8. I have the decoder wired to channel 8 on the receiver however I am not sure if there is something that I need to do on the transmitter to make this work. As mentioned, the transmitter I am using is a T14SG. I am decoding to PPM because I want to connect to the ImmersionRC Long range transmitter and this only takes PPM as an input. Images are attached below.
I initially thought that I need to register the PPM encoder with the T14SG the way that an SBUS servo is registered, however, I was not successful in my attempts and therefore I am contacting you in hopes that you will be able to explain to me what I am doing wrong and how to do it right.
Thank you in advance for your help!
Images of my intended setup:
