GPIO OUTPUT

[WaveFiZ]

Hi,
Very nice project steve
I'm using this project to manage 2 heater with same method ( PID control ) ,without Jeelabs Thermo Plug circuit board (1wire and GPIO) and Jeelabs Output Plug (I2C); "the raspberry pi connected directly to SSR relay", but I can't identify GPIO Output (BCM or BOARD) number.
Even after the configuration in config.xml The output PID not working ...And parameter control only the GPIO control panel PUMP/STIR1...
Please i need help with this issues and thanks any way 👍

[lalo-uy]

Check that the GPIO pin is not exported to the /sys/class/gpio/
My collide with that.