This repository was archived by the owner on Jan 17, 2026. It is now read-only.
patch: Update DTS Pin Usage For Seeed PCI Hat To Free Up I2C Bus 1 (GPIO Pin 2 & 3) #18
Conversation
This file contains hidden or bidirectional Unicode text that may be interpreted or compiled differently than what appears below. To review, open the file in an editor that reveals hidden Unicode characters.
Learn more about bidirectional Unicode characters
Correct the pins referenced by `mm6108` and `mm8108` when using the Seeed WIO-WM6108 Wifi Halow module on the WM1302 PCI HAT.
Contributor
|
Awesome Thank you, we will get this pulled in. |
coreywagehoft
added a commit
to OpenMANET/firmware
that referenced
this pull request
Dec 14, 2025
Sign up for free
to subscribe to this conversation on GitHub.
Already have an account?
Sign in.
3 participants
Add this suggestion to a batch that can be applied as a single commit.
This suggestion is invalid because no changes were made to the code.
Suggestions cannot be applied while the pull request is closed.
Suggestions cannot be applied while viewing a subset of changes.
Only one suggestion per line can be applied in a batch.
Add this suggestion to a batch that can be applied as a single commit.
Applying suggestions on deleted lines is not supported.
You must change the existing code in this line in order to create a valid suggestion.
Outdated suggestions cannot be applied.
This suggestion has been applied or marked resolved.
Suggestions cannot be applied from pending reviews.
Suggestions cannot be applied on multi-line comments.
Suggestions cannot be applied while the pull request is queued to merge.
Suggestion cannot be applied right now. Please check back later.
Correct the pins referenced by
mm6108andmm8108when using the Seeed WIO-WM6108 Wifi Halow module on the WM1302 PCI HAT.The most recent DTS patch related to the Morse device specifically targeted Morse Micro's own evaluation kits. See this post on Morse Micro's forum. In that same post, the OP also provided the updated DTS for use with the Seeed boards.
For this PR, I am just making the minimal changes to use the correct PINs for
power-gpios. This would free up I2C Bus 1 for other uses.